Don't like the adverts?  Click here to remove them

Starter contacts

Chris

Super Moderator
Supporter
Joined
Feb 24, 2010
Messages
17,937
Garage
Country Flag
great_britain
Got around to replacing the stater motor internals this morning. Someone had definitely been there before me, I think that it may have been a recon unit rather than the original. If this is not the original, then the contacts were in a very poor state for a vehicle with only 105k on the clock in total. Maybe it was replaced very early in its life.

IMGP4129.jpg


The main feed contact was burnt to a thin edge

IMGP4131.jpg


Not a difficult job, but getting to the top nut is a PITA. You need to tie the bunch of connectors with some string, lift them up out of the way and secure them to a point on the bulkhead. Then you can at least see what you're doing.

Doesn't fire up any better, it was fine to start with, but it does sound altogether better.

Chris
 
Back
Top