Search results

Looking for a sock glass for my Australian 1982 FJ45 left door (pass side). Door has a wing vent so it would be the more square style glass. Just need the one without scratches and no chips in the surface or corners. See picture. In the US so will pay the shipping. PM me Thanks

Wanted 1978-1985 FJ40 Radiator support and shroud standard 22" wide. Thanks

I have a 1982 Fj45 from NSW Australia and it is a real bad radiator that needs to be replace. Found out that the radiator is not the 22" wide standard 40 series but is 23.5" wide as is the core support, it was mad to accommodate a A/C set up. Apparently they installed them in most all 45s even...

Has anyone had some of the stock style exhaust flanges with the groove cut in the center for the stock gasket made. Seems as in the US not one can be found. Looking for a set of 4 for a complete exhaust rebuild.

Anyone have a 10 spline input shaft from a 3 or 4 speed FJ40/45 transmission that still has good splines. If so we can use the spline end if cut off from the gear end and is usable. Give us a post. Thank you

Well we are doing pretty good so far on the PTO build but still lacking the PTO end slip spline and flange yoke assembly. Anyone have one willing to sell? Looks like this :pray: Thanks

We are looking for a PTO gearbox (split case type) for a four speed 1982 FJ45. We have all the other trimmings to complete the restore but the correct PTO case. Seems as around 1980 the PTO gearbox changed in its design, the older mount bolt pattern went from an offset pattern to more of a even...

Wanted to share this with some of my fellow 40 series builders. I just finished a FJ45 the first one I ever did in a 45 type. I have had many FJ40s and have done some pretty hard off road driving with them. When it comes to off road driving we know that we can easily acquire small and large...

Did they change ToyoDIY web site to just viewing of the parts recently as I now only get the part numbers and no pictures of the parts.

Hi folks I am just finishing up a full Australian Toyota FJ45 restoration. I am now getting ready to installing the factory PTO winch but to complete this I need a few parts. The parts needed are the drive shafts with hangars and the PTO gearbox. The gearbox needed is of the 1981 and newer...

New to the club and hope to fine some new friends. Cheers