G
Guest
Guest
Benoit
Re Beerfields:
I re-built the front end recently - bearings, seals, gaskets
Before I did the work I tested the beerfields - no clunking noise - so
didn't change them out.
I did remove them & cleaned out all the old grease etc.
When puit back together and tested - clunking noise was there when
turning hard.
I was preparing for another stripdown to install new beerfields. So
will be interested to see how your diff inspection goes.
Re Motor noise:
Have you checked you UJ's ? - this appears to be the most common source
of noises and vibrations in cruisers. Especially if it vibrates more as
you increase speed or load.
Cheers
Niall
Re Beerfields:
I re-built the front end recently - bearings, seals, gaskets
Before I did the work I tested the beerfields - no clunking noise - so
didn't change them out.
I did remove them & cleaned out all the old grease etc.
When puit back together and tested - clunking noise was there when
turning hard.
I was preparing for another stripdown to install new beerfields. So
will be interested to see how your diff inspection goes.
Re Motor noise:
Have you checked you UJ's ? - this appears to be the most common source
of noises and vibrations in cruisers. Especially if it vibrates more as
you increase speed or load.
Cheers
Niall