DIY Draw system

[Guest]

john john!!!!
you do realise you're in grave danger of becominhg an expert on Land
Cruisers!!!
if you do i will be the onlyone left with absolutely no idea what anyone is
talking about..
I get in..I start it..I drive to australia..ipso facto it must be ok! whats
the problem????.....sheeesh dont leave me john!!!!
jeff
_________________________________________________________________
Got a favourite clothes shop, bar or restaurant? Share your local knowledge
http://www.backofmyhand.com

 

[Guest]

Hey Jeff
Not a hope im sorry to say of me going anywhere unless its to the local
shops.
I lost a lot of info when my ------ pc decided to melt and I reakon I have
forgotton so much and have no reference to what I had acumalated in the
first place with all the help I got from the list.
I nearly got to the stage that I could nearly convince myself I knew
something.
So now Its really a case of did I ask that, did I get an answer to the
question or do I THINK I know, but alas its usually not the last. Even now I
have problems with sending replies which wont send for days and then they
do, so may be a bit too late .
cheers
john 92HDJ 80 1HDT
SNIP
you do realise you're in grave danger of becominhg an expert on Land
Cruisers!!!
if you do i will be the onlyone left with absolutely no idea what anyone is
talking about..
I get in..I start it..I drive to australia..ipso facto it must be ok!
whats
the problem????.....sheeesh dont leave me john!!!!
jeff

 

[Guest]

Alright John
Re > Upgrading brakes and stuff for the extra weight.
Yep, thought of it alright but if then vehicle's under the GMV I'll be
happy enough to run with OEM gear and adjust driving according to the
road conditions and vehicle capabilities considering the load.
Cheers
Niall

 

[Guest]

Alright Julian
Re > I wouldn't want metal sheet due to the noise
Fair point - will need to address that in my DIY job
Thanks
Niall

 

[Guest]

Hi Niall,
When joining the sheet metal to the frame, try a bead of silicone
sealant or something like that to act as a gasket in the joint - this
should reduce the noise a bit.
--
Regards,
Julian Voelcker
07971 540 362
Skype: julianvoelcker
Cirencester, United Kingdom
1994 HDJ80, 2.5" OME Lift

 

[Guest]

Hi Niall,
When joining the sheet metal to the frame, try a bead of silicone
sealant or something like that to act as a gasket in the joint - this
should reduce the noise a bit.
--
Regards,
Julian Voelcker
07971 540 362
Skype: julianvoelcker
Cirencester, United Kingdom
1994 HDJ80, 2.5" OME Lift