Exhausts (80)

[Guest]

Hi Guys
I had a look at the rear and just over the axle it is welded why I dont know
and it would appear this could be next. Geese I had a look at the bend and
it must compress the exhaust to about one inch there, what a load of bad
design. on Toys part. Correct me if im wrong but is the exhaust only as good
as its smallest part (the compressed part 1 inch) this must be causing a lot
of back pressure all along the rest of the exhaust. I am not too up on back
pressure but I know its bad for the engine I think.
John C
92HDJ 80 1HDT Ireland

 

[Guest]

Header =3D Exhaust manifold.
No need, or , ability to change on the diesel engine.
Stop worrying !
Gareth Jones.

 

[Guest]

Hey Gareth
Sure tis in me nature to worry over things. I tried to put the bandage on
the top whel of the flexy joint, geese what a pain, you need two extra hands
I think to do it properly. Decided to have a look at my brillient work and
found that the lower weld has a few holes. Guess ill have to sell one of the
kids to the bank again for a new exhaust.
John C
92HDJ 80 1HDT ireland