G
Guest
Guest
Hi All,
I have recently had the timing gear's and IP removed for installation of a
new oil pump.
All went back together correctly but we cannot get the motor to run
properly.
It ticks over ok but will hardly rev to 2000 rpm and sounds rough and
produces white smoke.
If we pump the primer whilst running the engine revs better but only while
pumping like a maniac.
We also have hooked a vacuum gauge to the where the pump sucks fuel and it
remained on zero, it was quite sensitive and I was sort of expecting to see
something, do you think my IP is stuffed? Or anyone have any ideas?
Thanks
Martin.
I have recently had the timing gear's and IP removed for installation of a
new oil pump.
All went back together correctly but we cannot get the motor to run
properly.
It ticks over ok but will hardly rev to 2000 rpm and sounds rough and
produces white smoke.
If we pump the primer whilst running the engine revs better but only while
pumping like a maniac.
We also have hooked a vacuum gauge to the where the pump sucks fuel and it
remained on zero, it was quite sensitive and I was sort of expecting to see
something, do you think my IP is stuffed? Or anyone have any ideas?
Thanks
Martin.