hillbillysimon
New Member
- Joined
- May 19, 2011
- Messages
- 18
Hi
About to fit new swivel seals to front axle on 80 series, but the swivel balls are quite badly pitted. In a cost no object sittuation I would replace the axle casing, but I'm trying to repair this on a buget. Has anyone tried a scim of 'plastic metal' over their rusty balls then a careful sand off to fill the pit marks so the new seals will hold grease ?????
About to fit new swivel seals to front axle on 80 series, but the swivel balls are quite badly pitted. In a cost no object sittuation I would replace the axle casing, but I'm trying to repair this on a buget. Has anyone tried a scim of 'plastic metal' over their rusty balls then a careful sand off to fill the pit marks so the new seals will hold grease ?????