Search results

So its been a long time but I've managed to sort out issues as well as sensors, working a little bit here and there over some weekends. Now the thing is, I've manually verified complete front and back wiring including sensors and replaced that were faulty. Now there are no error codes or...

No, the rear sensor switch and wiring is intact and ok till ECU. Can you link the sensor testing method you mentioned? I did search earlier but didnt find it or are you referring to feeling with fingers?

So I had a chance to spare some time to look around last weekend. I measured voltages and resistance on the normal two pin connector, the green one didnt read anything as it were a floating pin, no voltage or continuity to ground. The gray one was live wire powering the LED light. However, I did...

Sure. I'm aware of the potential bumper/sensors issue and believe most probably some sensors are shot as I get a long warning beep at startup which I'm trying to diagnose which requires this missing switch but I'm hopeful. Will give it a shot this weekend.

maybe, but I've got the itch to get it working :cool: Thank you for the offer. I'll try the DIY route and see how it goes.. If not will look for a backup.. Dont want to bother you with Int'l shipping

Thank you.. that's the one I was looking for.. from documentation, besides the two pin connector it should also have a ring terminal for grounding. I bought mine used and it had tpa800 already installed albeit with missing bits. This button is completely missing. the connector are left hanging...

I know its an old post but can someone please confirm wiring connections of front switch, the one with LED ( I mean inside the switch, which wires it shorts when button is pushed). Reason is mine is missing and I cannot find a replacement anywhere. It seems a simple enough switch without any...