Recent content by 95lc80series

If you take out the EFI main relay the CEL light will not show when trying to start the vehicle.

The ground is fine. It’s an ODB2 vehicle I have scanned with a 100 dollar matco scanner and 7000 dollar autel scanner. It’s does not throw codes. Supposedly the only scanner that would work properly is an older snap on.

Yes I checked ignitor bracket and no corrosion.

Ok so a lot of message boards say if the CEL light comes on when putting the key and turning that it is not the EFI main relay. If the EFI relay is bad the cel light wouldn’t come on at all when attempting to start. Is this true or false?

Just to confirm and be absolutely sure it is not the EFI relay. I would not have a check engine light on the dash correct if it was the EFI relay? Is anyone absolutely sure of this.

I can smell gas fumes when I take off the air filter. I have been trying to start it a lot.

It says on it caution adjustment is required to prevent false alarms. It says refer to installation manual or 26p connector.

I see the Toyota security system electric control system under the dash. It has options for on and off. None of the wires look bad or chewed up.

Dave 2000 I just wanna clarify you mean the EFI relay correct and what specifically do I check for in the ignition system?

No leak of petrol under the vehicle. Does the security immobilizer make the vehicle crank and not run or does it shut down the battery? When changing the battery could it have triggered the security?

Looks like they got in the rear cargo area and under were the passenger seats are. I drive the vehicle a lot so it’s amazing they are still able to stay in it or wanna stay in it. I don’t see any chewed wires. The weather has been cold here could it be a stuck fuel pump? I have just above a...

Good call it looks mice were inside but I haven’t found what they chewed yet.

Ok if that’s the case what would I check specifically on the ignition?

It’s a petrol. Are there any other ways to narrow down the issue?

1995 odb2 80 series won’t run Checked fuses and relays. New battery is in. All the dash lights come on and it cranks. Any ideas?