Here is a small video of the webasto running. I connected the webasto inline after the viscous heater.
Now i'll be working on the remote start. I found a cheap remote car starter for 50$, hopefully i'll be able to wire the remote starter to operate the webasto instead of starting the car...
Yeah not many explanation, there is a connector holder where i located the spill control, and the slotted hole bracket is my doing. I did that so i could fit the bracket there.
Tomorrow i'll fabricate the bracket to hold the webasto in place.
This morning i tried to figure out where it could be installed, there is really only one place and it is next to the fuse box, but the driver spill valve control box need to be relocated. I did that and it took me a while to figure out why my truck wouldn't start with the control tossed to the...
Assuming there can be resistance through the viscous heater, why not connect in parallel or T just before the viscous heater? It could create a loop between the viscous heater and the webasto? A check valve at the inlet of the webasto would prevent that?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.