Hi all
i have a 4 inch lift dual wheel carrier, long range fuel tank which weighs in at arund 155 kg. i need a heavy duty constant load but what kg? is 350kg plenty to hold rear of car up maybe get drawers later.
i have 150kg on at min wrong springs shocking at rear. dobinson springs
this...
That's what I was thinking Shane. Just getting new springs same ones mate just more of a heavier load. These new springs got on have only been on 2 months can sell them put money towards new springs.
will a constant heavy duty heavier load Spring 350kg hold it higher. With it sagging so much...
Hello all.
i got 4inchlift on my 80s they sent me wrong rear coil springs and I cannot get refund from eBay paypal e.t.c.
they sent me a constant load of 150kg. I have a dual wheel carrier does two tyres, a long range fuel tank all in weighs around135kg. The rear sits 2 inches lower than the...
Hi my car after my 4 inch lift sits lower on drivers compared to passengers side by 25 mm 1 inch.
checked Spring says front right and left and it is ok but as the spy's left is that from inside of car. front right in car and is drivers but from outside car looking forward f right is passengers ?
Asked this before in another segment just want a new thread on it.
when measuring a 4 inch lift from the bottom off wheel arch to the arch or flares, what is it in mm..
Anyone know now any off these measurements a 2 inch 3 and 4 inch from bottom off rim to the flare :icon-cool:
john
Are these measurements good for lift 4inch. I have seen some look lower. Don't know what it is meant to be.
does anyone know measurements of lift 2inch, 4 inch, 6inch always wondered about the measurements
M this is left hand side passengers side 880/885. Right hand side 860mm. Can check out see what you think measurements are. Checked Spring front leftis passenger and opposite drivers side
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.