I do offroad winch challenges and am looking for a new LJ70 gearbox crossmember so it's not as low.
Couldn't see any off the shelf parts so will be designing & making it myself.
To get the correct height does anyone know if the crossmember is supposed to be flat underneath?
im looking for a 40 series Landcruiser for my next restoration project.
Anything considered, from MOT fail to rust bucket!
preferably Diesel and RHD But not essential
I’m Based in the midlands but able to collect from most UK places with a trailer if required.
Please comment or...
Hi all, bit of diagnosis/solutions to this:
I put an in-line clear fuel filter and found that the starting problem is the diesel draining back to the tank over time. The fuel lines are quite rusty so I’ve ordered new fuel hoses which should cure it.
The thermostat was blocked up with its own...
I've had a read of that thread which is quite informative, hope I don't have a cracked head though?! Thread Link below if anyone is interested
I think the auto cooler is bypassed but I'll check, and the engine...
Hi Shayne, tanks for the reply, I have lots of blue and pink for my other vehicles but am not familiar with red...
It is an Auto yes, and has had a separate oil cooler added already by a previous owner.
For a few months I've had a intermittent oil temp warning light that comes on after 5mins for a few seconds. The engine tempts normal so put it down to dodgy sensor.
Most recently The front heater matrix doesn't seem to get warm anymore and now more worryingly after starting up the...