Recent content by thedickmoody

Howdy Folks, Getting this thread going again, after a long hiatus. Finally got the body work done.... Looking for advice on wiring, I have a 3FE that is ready to be swapped in with a full harness from an automatic 60 series. My plan is to keep the manual trans from my 80, but with the...

Peeled back a bit more of the engine bay to expose these rust problems on the fire wall where inner fender meets it. Tried some googling to see if there were any replacement panels.. no luck. Any thoughts for the best way to attack this?

Hello Again, The old 3F is finally out! Ready to get going on the new 3FE now. Had a question regarding the fuel system. Currently I have two fuel tanks on the truck from factory. Do they both operate as separate tanks, as in both have fuel pumps or does the reserve dump into the main...

Howdy! This is my 1990 Australian 80 Series currently with 3F motor. I shipped it back home to Canada (Alberta) and that carb does not like the cold temp and higher altitude. I was able to find a 3FE to swap in for more reliability. I was hoping that there was some information or tips on a...