Recent content by V8 or be Late

Bob. where did you get that rear spoiler over the taildoor.??

Looks well there Bob!! I have the glass and mine are tinited, cost me 80 quid to get done.! its great for keeping the sun out and keeps my cplorado cool in warm weather over in Europe.! I hope yours stays cool inside because the black might attract a bit more sunlight, although you got the...

Thanks everyone for the info. I will be fitting the seats back into the middle row once they are dried out. The only other thing is that the speedometer and odometer dont work.! Ive tried all the connections and cleaned the rotor assembly ar the back of the transfer box but still not working...

ok thanks. the 3 seats that are still in have working seat belts and its my plan to bolt them back in again after they are cleaned and dry.!

Hello everyone.! Im going for my MOT next week and i have a 2001 Colorado 95 model with the 3 row of seats, 8 seats in total.! I have the back row out and have also removed the 2 seat piece behind the drivers seat to clean the covers because of spilt shopping.! i still have the single seat...

if it continues to drip, then your filter is leaking or is not properly sealed .!! so keep an eye on it.!!

Yes, this is a good tip,! i had no problems with the 24 mm plugs.! i had the problem with the 10 mm hex Filler plug on my front diff.! was dificult to get into weld it so i eventualy tack welded a 10 mm 316 Stainless steel nut to get it removed, then at a bech and vice removed the stainlees nut...

I got a new set of wheel nuts and a set of locling nuts from Milners ! you need to get the type with the flat washer. because it fits snugly onto yhe alloy wheel.! the ones i got are shorter in length and fit perfectly onto stock wheels and studs,! they looked realy nice and sit inside the wheel...

Thanks Bounder.! Does anyone know if it is a big job to drop front diff out to change inner seals or can it be done from each side.?

Theres a thread on here about the power heater on a 95, its under Whats This.? i think its a few months back loook on page 4 or 5 ?? its just like the aircon compressor but it pumps the coolant through pipework in a heat exchanger on the exhaust manifold directly to the interior heater so warms...

I have the same problem with the 10mm fill plug on the front diff.!!!!! impossinle to drill, weld or grind in there because its up against suspension frame.!! can i top up my diff by filling it through the small breather pipe that comes up into engine bay.??? my 2 front inner seals are leaking...

Does anyone know how much Diesel a 3.0 Litre D4D engine uses at idle per hour .??? mine idles at around 620 RPM when warm !!

I think the oil seals on my drive shafts are weeping slightly because after I have driven it and park up it drips a little bit.! Is it a big job to replace the oil seals.???

In the movie Eyes Wide Shut, he drives a Rangerover P38. It is a good film too but a bit far fetched because the rangerover is working in the movie.....well only for about 30 seconds in the film.!!!

Im not sure if mine is strectched or fully adjusted, I might try adjusting it tomorrow and see. If it needs replacing I will chance one from Milners.!