Recent content by Yatys93

yes actually that is exactly what I was after, can shop online to find the parts and 2 birds one stone sort of speak while I have the shifter apart I can redo it Thank you!

I have a 98 3.4l manual, I am going to be doing extended breathers in the next few days, to get to the gearbox and transfer case we can just dismantle the interior around the shifter, so wondering how much work it would be to also replace the bushes on the shifter to stiffen it up and get rid of...

yaaaa pioneer 5 channel with an RMS of 1000w, wants 90 amps just to itself which will make it a bugger to run, however 140amp alternator while be fine for either heavy winching or music, and if I'm stuck the music will not be cranked so the amps power draw will be a lot less, I still have a few...

ya that was my thoughts too that just decent care and a cleaning and it should be fine, I'm not sure if it's any different between the 90 and the 95 but the ones down under get an 80 amp from factory, which will be fine for my camping set up, fridge winch and lights, but I was also looking into...

been hunting for a while for a higher amp output for the 5VZ, and at least here in Australia they don't really make them, can get them for the diesel but not mine, and kinda gave up on it, then while looking up on where the stock ground wires are to do a big three I found the timmy the toolman...

Honestly couldn’t tell you, the ones I want to buy are tough plastic Factory Style Flares Suitable for Toyota Land Cruiser Prado 95 Series 1996-2003 - [Leaving Land Cruiser Club] So ya these will go on at some point in the next few months but I need to fix the suspension first

Yaa welcome to Aussie road laws That was my concern was how much work would it be vs spending more on aftermarket ones ADR stands for Australian design rules, basically anything on a car over here has to meet their standards, I found some nice flares on eBay that would have been great but...

Hoping someone here as some ideas, working on getting it ready to pass a roadworthy (Vic) and one of the issues is the rims it came with stick out passed the body, so temp fix the rubber flares (yes I know I did it wrong, will redo when the hub centering rings arrive so I don't have to jack the...

I was thinking the same, seen both a 120 and a 150 upgrade option, need to sit down once I pick parts and actually do the math on what I need, I’m also in Aus jumping through hoops to get this thing rego’d again, the rules over here are just crazy, which state are you in? Currently I have the...

In the process of fixing then upgrading my 98 prado, have already added a second battery in the rear for my fridge and upcoming camp lights and maybe inverter to charge batteries (camera, drone) also debating adding a 2nd starter battery under the hood to give me extra breathing room for high...

currently in the process of updating a 2001 90 series land cruiser prado, adding a few small electrical parts, and wondering if it's possible to add an accessory powered bus bar? say run a wire from an accessory fuse to a relay, then from the relay connect to a battery? just with looking at...

This may sound stupid, upgrading the spot lights on my prado, and stupidly left the nut off of the positive battery terminal on top of the battery, I have no idea where the little bugger has gone, I spent over an hour searching because without it the car won't start, and I had to move the car...

Ya you aren’t wrong there

ya I think what I'll do is grab a pack of half and 3/4 length and then I've got a back up if the half's don't hold, and if they do I'll return the 3/4