Don't like the adverts?  Click here to remove them

head

  1. R

    Seeking Advice on KZJ70 (1KZ-TE) Head Replacement: Should I Stick With It?

    Hi everyone, I could really use some advice. I’m currently in the process of replacing the cylinder head on my KZJ70 with a non-OEM head. Upon opening the engine, I discovered that this isn’t the first time it’s been worked on—the head that cracked wasn’t the original one either. The engine is...
  2. alexbnk

    HOT/COLD Climate head gasket, truth or myth

    I have towed 1.5 tons for 150KM in 30C and the engine overheated occasionally. Due to a balancer shaft bearing failure that cause zero oil pressure i had to take it apart in order to replace the bearings and one shaft. After removing the head i was amazed to see that most of the water passages...
  3. Peewee

    Main Beam Delay

    Early 2006 HZJ79R When I first twist the knob to turn on my low beam it works fine. Occasionally when I flick the stalk forward for main beam my lights will go out for 2 or 3 seconds. After that it usually works fine Any suggestions?
    • Peewee
    • Thread
    • beam delay head headlights lights main
    • Replies: 2
    • Forum: 70 Series
YYY
Back
Top