Recent content by UNWORTHYPOTATO

Good news! I have successfully taken apart the front steering knuckles, and I am currently 3d printing a pedestal to scan all of the pieces necessary for my project. I expect to be finished with this corner of the project by the end of the week. (WOOT WOOT)

UPDATE: I have just made the logbook for my website which I will update at leas weekly, I will be setting goals for myself to meet on a short term basis. Additionally, the laser scanner that I have access to will be fully available to me after fall break (about 2 weeks), after I get the scan I...

UPDATE: Good news is I have gained access to a 3D laser scanner, courtesy of a nearby campus, I will be disassembling the pieces that I need scanned next week. I will be doing the last wheeling trip of the year on Saturday, then it is down to business... wish me luck!:D

that sounds cool, and worth a shot. how would one do such a thing?

UPDATE: I have just published the website that i will be updating and using over the course of this project, I will also be starting a blog, these sites are for the class that I am taking. The website has next to nothing on it except for a picture of my cruiser and a little note about myself...

Yes, i have been using the video and their website for most of my research, it is very useful, but I stil need a few specific measurements.

thanks, do y0u have a link?

Thanks for the info, yes I can continue posting as the project goes along. I will look into the laser plot idea. thanks again for your help

I am a high school student attending Eaglecrest High School and I am working on an engineering project in which I will design a bolt-on portal assembly to put on my cruiser. The only problem is that I will need accurate measurements for the front or rear axle and trunnion assemblies. If anyone...

Various pictures my toys

My offroad trips

My build thread