Recent content by Will_LandcruiserFanatic

So I've recently bought this Ute with 400000kms, very sluggish and pulled a code PO299. It blows a shit tonne of smoke when I'm idling after driving it as well as a consistent tiny trail of blue smoke while driving. it blows more smoke the lower the rpms essentially. anyway, so i am unsure of...

Actually, funny you say egr and throttle body as there’s a few videos and comments indicating it could be this…..

It should be up too date with servicing I did a filter and oil probably 1000kms ago

have an lj71 with the 2lte engine. blows heaps of smoke on idle and when accelerating from idle especially. loads of blowby coming from oil cap. have a theory that the blowby is pushing oil past the stem valve seals and up the hose into the turbo crossover pipe (intake) and then burning. has...

so done abit of asking around, in order to achieve a 3 inch lift.... rear - stock front springs in the rear along with stock 80 series shocks. (alot more travel) front - 3 inch kzj78 in the front + stock 80 series shocks. not 100% on this but can work as long as the shocks are pin bottom and...

have a 1991 lj71 prado with the 2lt turbo diesel engine, want to do a 2-3 inch lift. just want abit of guidance, has anyone else done a lift on one of these and what works best?

That would be great thanks mate!

No it’s a 4L straight 6 (3f) with a meaty tone since it has a 3 inch exhaust, I think it should be fine

Just bought my 75 1992 model, wipers haven’t been working at all, replaced the fuse and as soon as I turned ignition it popped, this is happening repeatedly as I fit a new fuse, I ended up pulling the wiper motor plug off and giving it a good blow, water came out after my wash, then turned...

Yeah I think that sounds like a great option since I have seen the 35 look too big but 33 slightly too small

Yeah I tend to think 33” are the better option, thanks for your insight shayne!

Just bought a 1992 75 series and was keen on buying some 33” tyres (285) with some new Mickey Thompson chrome mags, but having thoughts of going bigger, I want a size that fills the void and is very proportionate without looking like I’m trying to make a monster truck Any suggestions???