Search results

I am looking for a buyer, outside of the high end auction sites, for my 1972 FJ40. I purchased it from the original owner and it has less than 100K miles and has never had any rust or body damage. Frame off restoration, every nut and bolt, frame and all such parts powder coated. FJ is light blue...

I am looking for a NOS or used horn button for a 1972 FJ40. Anyone?

Just finished my FJ40 restoration. The last project was installing gas struts inside my stock rear hatch lift tubes. This was a 10 minute project once the research was complete and the correct gas struts sourced. This was the idea project a completely rust free one owner FJ40 to start the...

I am in need of a NOS Emission Evaporative Control Device for my 1972. I believe it is part# 17650-60012.

I have an early FJ40 single barrel carburetor. It has not been overhauled. It is complete with bottom vent plate and insulator plate. Make reasonable offer or email for photos. [email protected]

I picked up a PTO winch for my 72 FJ40 last night. I need the following parts for install. 1. Drive shaft complete 2. Complete mounting frame 3. Linkage parts (at the transmission tunnel) 4. Any combination of these parts or a complete non-working unit for parts. Thanks JLP

I picked up a PTO winch last night but need the following parts for install: 1. Drive shaft 2. Mounting Frame complete 3. Linkage parts and lever that for transmission tunnel 4. Any combination of the above or a complete non-working unit that I can get these part from. Thanks for looking!

I have an F Engine from a running 1972 FJ40. It was taken out for a V8 upgrade. I purchased it with a lot of other take off parts. I do not need the engine. Local Pick Up Only!:think:

I am in need of the two brackets that mount under the right jump seat to mount the jack rods. I also need the jack rod extension, (second of the two jack rods), this rod is approximately 23" long. This is for the 1972 FJ40 Land Cruiser production date of January of 72. Thanks for looking.

Set of as new BF Goodrich TA KO's 31X10.5X15". They are on a used set of wagon wheel rims. They are take off's from my 1972 FJ40. I went back to original rims with original size KO's. I will separate tires and wheels if you are interested in one or the other.

I am looking for one of the last needed parts for the restoration of my 1972 FJ40. I need the dash mounted interior light (map light) it mounts just to the outside of the glove box door. I looks kinda like Darth Vaders helmet.

I am looking for the dash mounted interior light for my 1972 FJ40. It is mounted in the dash just to the right of the glove box door (left hand drive). I really need this part for my restoration.

This part looks like a condenser but is attached to the coil on the same bracket as the ballast resistor. The condenser is located on the distributor.

I have the original tool bag for my 72 FJ40 but need to pick up the tools. Anyone have one or more? Any? Please let me know. [email protected]

I am a classic Datsun 240Z owner and former Owner Racer of Datsun IMSA Car #29. I recently purchased a 1 owner 1972 FJ40 (rust free) and I am in the process of restoration. All of the body pieces are out for soda blast. I am sure that I will be asking lots of questions, if this is anything like...