Search results

It could possibly be the shut off valve on the throttle body, it is vacuum controlled and altitude could cause it to close and cut off engine?

Check there is no damage where the seal seats, sometimes upon removal if a screwdriver was used in the past it can cause damage. I've done a few and now only use genuine seals as found aftermarket seals always leak no matter how careful you fit them.

I think its fixed!!! ?? Today I got to the Landcruiser in to see what the braking fault was. Thanks all for the suggestions, so to cover all suggestions things I checked were- tyre pressures fine, wheel bearings no play, tie rod trailing arm bushes all solid no movement, flexi brake pipes sll...

Hi everyone, my apologies for not getting back to you all sooner, I have been in hospital so haven't had chance to do anything yet, this weekend I should hopefully know, again thankyou all for the advice.

Hi, I am going through all the suggestions this weekend, if I find the fault I will let you all know. Thanks all for the advice its very much appreciated.

Hi Beastrider, yes all suspension components are good, tyre pressures good, I had the front axle seals replaced with new wheel bearings 12 months ago, I've spent a lot of money on it and keep it very well maintained. I haven't checked the metal brake pipe from pump to flexi yet so will do that...

Yes agree about alignment etc but a few years ago I had all trailing arms and axle bushes replaced with poly bushes. I have used a lever bar underneath and checked for play. The steering stays straight when driving, I've even checked the tyre pressures. It is just like not enough pressure is...

Hi Chris, you're thoughts are spot on, it has to be the left not getting enough braking pressure so to pull to the right. I will have a look at the rear load valve but say for example it was stopping fluid to the rear left would that be enough to make it veer so hard to the right? I wondered if...

Thanks for the reply David, yes I thought the same, pistons were checked and they push back freely and the pads move freely aswell

Hi, I've got a 1997 80 series Landcruiser, it has a braking problem, it veers to the right quite hard when medium braking. Over the last 18 months I've had all 4 callipers replaced with new, new discs and pads and all flexi hoses replaced with new. It has ABS, the abs light comes on with...