Hoping someone here as some ideas, working on getting it ready to pass a roadworthy (Vic) and one of the issues is the rims it came with stick out passed the body, so temp fix the rubber flares (yes I know I did it wrong, will redo when the hub centering rings arrive so I don't have to jack the car and remove wheels over and over again) these rubber bits will work for Vic roads but I hate them, tried to find some aftermarket flares but all I can find are ebay units from Thailand which I highly doubt with be ADR approved.
as can be seen in the picture though I got one without the factory flares, so wondering if I go to a wreckers and buy all the trim pieces and extra mounting bits, other than cutting some holes they should fit right?
thoughts and ideas would be greatly appreciated, and yes I could replace the rims, but trying to avoid doing that as once it's road legal again it will be having some off road work done, including a lift and then I will be getting bigger rims and tyres for it, so would rather avoid buying 2 sets of rims in as many months.
Thanks all
as can be seen in the picture though I got one without the factory flares, so wondering if I go to a wreckers and buy all the trim pieces and extra mounting bits, other than cutting some holes they should fit right?
thoughts and ideas would be greatly appreciated, and yes I could replace the rims, but trying to avoid doing that as once it's road legal again it will be having some off road work done, including a lift and then I will be getting bigger rims and tyres for it, so would rather avoid buying 2 sets of rims in as many months.
Thanks all