Recent content by cbv8

Surface rust only on the chassis no welding done or needed

Thanks i will check tomorrow :thumbup:

Ok i will take £19,000 :lol:

Hi, I am thinking of selling my Colorado he has done 134k miles two previous owners is a VX automatic D4-d lots of service history bodywork is rust free as is the chassis has never been welded and is solid has had new Toyota cambelt all fluids changed has 11 months mot one advisory ie front...

Hi All, Looks like i spoke too soon after driving my Collie around for a while the gearbox seemed to have sorted itself ie reverse gear was back that is until today when it lost reverse then when cool comes back again i really don't believe i am saying this but i think me and Collie...

I dumped the 20/50 oil after a few miles then put Helix 10/40 and after running for a few more miles put the proper spec 5/30 fully synthetic in at least the engine oil is super clean after two flushes :lol:

An update on my Transmission after driving it round and about the reverse issue is no more ie i have reverse gear but to be on the safe side i took it to my Trans specialist who did a stall test and hooked up his diagnostic equipment and low and behold no faults no slippage nothing :dance: The...

Not fitted yet i will post when i have sorted all :dance:

Thanks iv'e just got to sort some chunky ATs now ;-) theres a few other jobs im doing first like fitting some bonnet gas struts and replacing those feeble taxi beep beep sounding horns i know trivial jobs but jobs that irritate especially the weighty bonnet. I have have done the oils/filters...

Thanks for the replies all, Andy i am putting Mitsi wheels on because i like the look of them and i cannot justify spending over £500 on a set of used LC 80 wheels nice as they are :oops: Shayne so basically they do fit if i put spacer rings on someone on fb has suggested 8-6mm ones below is a...

Hi All, Can anyone tell me if these L200 alloys will fit my 02 Collie the only difference between my wheels and L200 is the offest and 2mm centre bore difference so am i right in assuming these will fit of will i need a spacer or something? any help or advice very much appreciated:bow-yellow...