I just replaced my brake pads, rotor, caliper and bracket, and I replaced my axle seal because there was a bunch of grease all over the inside of the rotor and I took it for a test drive and there is some faint smoke coming from it.
Anyone have any ideas?
sob
My oil pressure is reading low.
I changed out the oil pressure sending unit and it still reads low.
I attached a presure gauage where the sending unit goes and and reads 40psi while ideling but still nothing on the dash.
Anyone have any ideas?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.