A few months back I 'had' 26 factory workshop manuals on a separate drive and I lost one, I have no idea where? So, I gave out a shout on this forum and a kind soul (Thank you) sent me a copy of said manual, so my collection was complete once again.
Tomorrow I am going to fit a couple of the HD Dobinson's lower trailing arms and as anything like this should be tightened with the car unladen so the ride height is correct however, my car has a full length roof rack fitted along with the usual tent/spare wheel/sand ladders/high lift jack and other odds and ends, so I need to jack the body up away from the axle.
So car is on the ramps ready for a start tomorrow morning, and I go to check the bump stop to axle clearance from one of my factory manuals and the one with the ride height info is missing? Now, it may have been the one someone sent me back way back when but I am not sure? So, I need the FSM or at least the bump stop to axle measurements front and rear, can anyone oblige?
Plenty of rim to arch measurements abound but nothing stock, my 80 is stock height as is the wheel size.
I hope someone is still up as I need the info ASAP.
The manual going missing has to be me slowly losing it, I have probably filed it under a name that has no bearing on the LC...or perhaps any car for that matter?
Many thanks
regards
Dave
EDIT: Just rechecked this post and found the lower half missing, then realised that between logging in and completing the post I had been logged out?
Tomorrow I am going to fit a couple of the HD Dobinson's lower trailing arms and as anything like this should be tightened with the car unladen so the ride height is correct however, my car has a full length roof rack fitted along with the usual tent/spare wheel/sand ladders/high lift jack and other odds and ends, so I need to jack the body up away from the axle.
So car is on the ramps ready for a start tomorrow morning, and I go to check the bump stop to axle clearance from one of my factory manuals and the one with the ride height info is missing? Now, it may have been the one someone sent me back way back when but I am not sure? So, I need the FSM or at least the bump stop to axle measurements front and rear, can anyone oblige?
Plenty of rim to arch measurements abound but nothing stock, my 80 is stock height as is the wheel size.
I hope someone is still up as I need the info ASAP.
The manual going missing has to be me slowly losing it, I have probably filed it under a name that has no bearing on the LC...or perhaps any car for that matter?
Many thanks
regards
Dave
EDIT: Just rechecked this post and found the lower half missing, then realised that between logging in and completing the post I had been logged out?
Last edited: