warrenpfo
Well-Known Member
- Joined
- Jul 21, 2010
- Messages
- 2,895
Right i have rebuilt and am assembling my front swivel housing and on giving everything a good clean and torquing the bolts and nuts to 65nm as per the spec i am getting 7kg on the scale with a 0.2 shim on each side.
I never measured it prior to stripping it down so cant say if it was right or wrong but to get each side in spec i am going to need quite a fem more shims on each side. I just wanted to ask those who have done it in the past is it common to have 4 or 5 shims on each side or there something wrong here.
I have made sure the bearing races are all the way home but cant for the life of me see where i might be going wrong.
Just asking
I never measured it prior to stripping it down so cant say if it was right or wrong but to get each side in spec i am going to need quite a fem more shims on each side. I just wanted to ask those who have done it in the past is it common to have 4 or 5 shims on each side or there something wrong here.
I have made sure the bearing races are all the way home but cant for the life of me see where i might be going wrong.
Just asking