G
Guest
Guest
Greetings all.
Spent the last 2 nights trying to get the tie rod & drag link ends replaced as part of general steering overhaul. The knuckles are sore & I'm no further on with the job.
The gear puller I have isn't up to the job, so I'm ditching the nicely nicely approach & going at them with a lump hammer and agricultural spec joint separator.
Question is - will I have as much trouble getting them back together? Do I need a special tool or is there a technique I should know about?
Any help appreciated.
Thanks
Niall
1995 HDJ 80 - with a tendancy to drift towards the ditch
Spent the last 2 nights trying to get the tie rod & drag link ends replaced as part of general steering overhaul. The knuckles are sore & I'm no further on with the job.
The gear puller I have isn't up to the job, so I'm ditching the nicely nicely approach & going at them with a lump hammer and agricultural spec joint separator.
Question is - will I have as much trouble getting them back together? Do I need a special tool or is there a technique I should know about?
Any help appreciated.
Thanks
Niall
1995 HDJ 80 - with a tendancy to drift towards the ditch