Just wondered if anyone else has had this issue?, I was trying to get the front and rear lockers to engage today as I wanted to check everything was ok before it goes in for front axle and diff work, the front diff apparently needs to be locked to be able to remove it so I need to engage the locker.
I don’t have the centre diff lock button so it should engage in low, but when I put it in low the centre lock isn’t engaging at all, I had a brief look online and believe I’ve found the sensor on top of the transfer box, I unclipped it but didn’t undo the sensor going into the box, I will probably do this tomorrow.
Is this the most likely cause?, I’ve read it can be the low range sensor too?.
Does anyone know the part number from Toyota for the sensor on the transfer box?.
All 3 diff locks were working last week when I test drove it, so I’m scratching my head a bit here.
Just ordered the sensor/switch that goes on the transfer box, if anyone else needs one don’t bother ordering one of the expensive ones, it’s the same as a reverse light switch for lots of Toyotas and is a lot cheaper to get, I paid £13 for it just now on eBay.
I don’t have the centre diff lock button so it should engage in low, but when I put it in low the centre lock isn’t engaging at all, I had a brief look online and believe I’ve found the sensor on top of the transfer box, I unclipped it but didn’t undo the sensor going into the box, I will probably do this tomorrow.
Is this the most likely cause?, I’ve read it can be the low range sensor too?.
Does anyone know the part number from Toyota for the sensor on the transfer box?.
All 3 diff locks were working last week when I test drove it, so I’m scratching my head a bit here.
Just ordered the sensor/switch that goes on the transfer box, if anyone else needs one don’t bother ordering one of the expensive ones, it’s the same as a reverse light switch for lots of Toyotas and is a lot cheaper to get, I paid £13 for it just now on eBay.
Last edited: