Search results

Just wondering if the low beam lamp (outer unit) is dual filament... without having to pull it out 'cos its a bugger to get at,,, At the moment my drivers side headlamp comes on when on low beam, but not my passenger. When I switch to high beam, all 4 headlamps light up... I'm also getting...

My clutch gets stiff to push at high revs.. What could the cause be - master/slave/air in fluid? Thanks Chris

Just fitted some new shades.

Is it worth fitting a CDL switch to a 97 manual cruiser? I've been reading through a few different forums that say it is a simple and worthwhile mod, but can't decide.. Also not sure which switch I would need - there appears to be two different ones - a push or a twist. I understand the...

I've not been offroad in low for a while .. I did today and the ABS and Diff lock lights were on .... Manual gearbox .. if that helps I can't remember if this is normal or not ?? Cheers

I had caster correction fitted a few months ago and not long afterwards the driver side (RHD) CV started grinding and so I had that replaced .. A few months on and the new CV is grinding now.. Are the 2 things related? Thanks

I just had rocker cover gasket redone. Now when I drive, if I hit accelerator hard, the engine cuts out, as in revs drop to zero.. lift my foot and she's fine again. Any suggestions on what to look for? It drives fine if I'm gentle on the accelerator and I can't replicate it when in neutral...

I'm looking for a part number for the little coin holder, storage bit that sits above the radio on the 80 dash. Cheers

Hi Very basic question, but I can't figure out which is the (manual) gearbox oil fill plug and which is drain plug... anyone able to post me a pic please? TIA

I've new fuel filler shield to fit into my 80, but notice there's some sort of foam/sponge protector stuck to the existing one.. Is this a required part? I can't seem to spot it on any of the fuel system parts diagrams

Anyone happen to know the part number of this fuel filler surround, mines slightly cracked, so want to replace... Ignore the red scribble.. it's the black surround I'm looking for

So my next job is to get the fuel filler flap to open, using the pull on the dash. The previous owner attached a wire, that can be pulled when you open the back door.. Going in behind the housing in the rear, I can see the cable is attached... However the mechanism itself is loose and can...

7" or 8" unit ??? - I'm gonna move the UHF

I've noticed a small bit of oil on my driveshafts - pics below - is this normal, or does it suggest a seal is gone/going? - I was looking at them to possibly regrease to reduce difflash As per this video using the Mercedes grease -https://www.youtube.com/watch?v=URl7Y93XWtQ) FRONT REAR...

Daft question, but .. how many of the Courtesy lights should operate when you open the doors? At present, only the one above the drivers seat comes on, and not the one in the console (with the subtank gauge) nor the rear one... #fixingmycruiseronebulbatatime Thanks Chris

Hi people I need to replace a corroded bulb holder for one of my reverse lights.. I don't want/need to replace the entire cluster. I've been googling, but to no avail - can anyone tell me the part number please - or direct me to one on eBay? Thanks Chris

Has anyone got a pic from inside the cabin, of where the wires go through the bulkhead please? TIA Chris

My Cruiser has solar panels fitted and the controller shown below. Can I rig up a 12v accessory panel (3 cig lighter socket panel) to this, running from the connectors that show the lightbulb. And if I can, will it be running directly from the panels, or via the battery? TIA Chris

Anyone know the route the filler flap cable takes to the pull lever? Before I start trying to rip up carpets? Thanks Chris

New to me - owner no. 3

Hi there Just picked up my first Cruiser #bucketlist - I wanted once since I was 18 - now at 53 I got my '98 40th Anniversary edition .. a bit rough round the edges, but hey, it's a Cruiser. Chris