G
Guest
Guest
Hi Simon
Welcome to the forum and good luck with your new tlc.
I can sympathise with your ABS problems as I am suffering from a similar
problem. I am still a beginner in this wrenching thing but there are plenty
of other people on the board that can advise you. I too have a stuck on ABS
light which has only surfaced since I replaced my wheel bearings and oil
seals. I need to dismantle the work I have done and re grease the knuckle
which will then leave the "ring" clear to be read by the sensor (I hope).
It may be worth having a look at this on yours too.
All the best.
Simon Hughes
K reg TLC 4.2l TD 156k
Welcome to the forum and good luck with your new tlc.
I can sympathise with your ABS problems as I am suffering from a similar
problem. I am still a beginner in this wrenching thing but there are plenty
of other people on the board that can advise you. I too have a stuck on ABS
light which has only surfaced since I replaced my wheel bearings and oil
seals. I need to dismantle the work I have done and re grease the knuckle
which will then leave the "ring" clear to be read by the sensor (I hope).
It may be worth having a look at this on yours too.
All the best.
Simon Hughes
K reg TLC 4.2l TD 156k