Can anyone recommend a good/honest cost effective welder in mid-Sussex way?
Having taken off my running boards I found some holes in the sills - not ideal but no great surprise.
When I took it in to my local mechanic who does MOT's it sounds more extensive and includes the sills, bits of floorpan and the inner wing at the right front. All within 30cm of seat bolts, body mounts etc.
I only bought it recently, MOT had a clean sheet and full service history so I paid attention to checking the chassis on purchase, which has lots of surface rust but is sound and in the process of being cleaned up. I didn't however expect this.
MOT runs out end July.
P.s. the forum has been super useful as a research and 'how to' so far so holding hope I can rectify cost effectively.
Having taken off my running boards I found some holes in the sills - not ideal but no great surprise.
When I took it in to my local mechanic who does MOT's it sounds more extensive and includes the sills, bits of floorpan and the inner wing at the right front. All within 30cm of seat bolts, body mounts etc.
I only bought it recently, MOT had a clean sheet and full service history so I paid attention to checking the chassis on purchase, which has lots of surface rust but is sound and in the process of being cleaned up. I didn't however expect this.
MOT runs out end July.
P.s. the forum has been super useful as a research and 'how to' so far so holding hope I can rectify cost effectively.
Last edited: