fridayman
Well-Known Member
It looks like I might have to replace a short brake pipe at the front as well as the two long ones that run from the front to the back. Even my Toyo dealer suggested that I shouldn't buy these from Toyo... I can go to the local motor factors, but when they supplied my heating tubes, all they did was cut the lengths and then flare the ends - I had to do all the bends myself. So now I'm thinking I might just buy a brake pipe flaring kit like THIS, or THIS, or even THIS ONE. Does anyone have any experience or advice on these tools / kits?
And how do I put sharper bends in the longer pieces without kinking/squashing the tubing?
And how do I put sharper bends in the longer pieces without kinking/squashing the tubing?