jonnyboy54321
Well-Known Member
Hi guys
I've been searching for a tutorial/pictorial but am struggling.
Got a couple of weepy injector seals on the 95. Not a job I have done before but i am reasonably handy and not scared!!
I spoke to Steven Eagells - they sent me four of each of these:-
T11177-64010 - gskt inj nozzle
T11176-64010 - n/stk gasket inj nozzle
One lot appears to be seats, the other seems to be bright washers.
Do I have the right bits/everything I need? Speaking to a mechanic pal he seemed to think there should be copper seal washers?
Any advice hugely appreciated.
J
I've been searching for a tutorial/pictorial but am struggling.
Got a couple of weepy injector seals on the 95. Not a job I have done before but i am reasonably handy and not scared!!
I spoke to Steven Eagells - they sent me four of each of these:-
T11177-64010 - gskt inj nozzle
T11176-64010 - n/stk gasket inj nozzle
One lot appears to be seats, the other seems to be bright washers.
Do I have the right bits/everything I need? Speaking to a mechanic pal he seemed to think there should be copper seal washers?
Any advice hugely appreciated.
J