That's a good thread to look at to see the internal gubbins from where it's probably leaking. As I suspected, I don't think that kit is much more than the external dust boot. It certainly doesn't have all the moving parts in it.
Don't like the adverts? Click here to remove them
Rear brake load sensor valve
- Thread starter Michael Montgomery
- Start date
That link is to Partsouq on eBay so either Partsouq or Amayama direct may be cheaper but it would attract VAT and post office service charge here, so may not be much in it from Simon Holton.
Michael Montgomery
Well-Known Member
Michael Montgomery
Well-Known Member
Guys today with the help of my cousins garage took the part apart and replaced the top seal gastket below the dust shield.
Thankfully this looked like the problem and so having found a suitable replacement out the part back together after a good clean and grease up.
Unfortunately having it done pretty quickly couldn’t share any pictures to share.
Update pictures taken from IH8MUD.
One black seal marked in green being the top below the dust shield also marked in green.
Hopefully in the the next week or two will tell how well it la been fixed.
Relatively cheap fix thankfully if it holds up.
P.s that kit shared didn’t have intervals for the part only being the exterior kit.
Thanks
Thankfully this looked like the problem and so having found a suitable replacement out the part back together after a good clean and grease up.
Unfortunately having it done pretty quickly couldn’t share any pictures to share.
Update pictures taken from IH8MUD.
One black seal marked in green being the top below the dust shield also marked in green.
Hopefully in the the next week or two will tell how well it la been fixed.
Relatively cheap fix thankfully if it holds up.
P.s that kit shared didn’t have intervals for the part only being the exterior kit.
Thanks
Last edited:
