steven.miles3
New Member
- Joined
- Oct 28, 2013
- Messages
- 9
Hi
Last edited:
A little bit easier for access with pipe off but a lottle more trouble! I left it on next time around.
BRIDGE :
1. Undo screw and nut.
2. Press down on other side with finger making sure no clearance.
3. Whilst pressing down do up the screw with driver until resistance is felt.
4. Fasten lock nut.
I think confusion may arise as once the lock nut is fastened there is no way to check the adjustment.
I cleaned the tops of my main rockers and numbered them 1-12 with a felt tip then crossed them off after adjustment. I got confused otherwise. lol.
Correction on the highlighted point:Digging up this old thread...
...Then on the loose rockers, adjust VB so its resting (no clearance) on both valves with a finger on the valve without the screw/nut just like the above quote....
I.e. you back off the adjuster screw above the valve, then adjust the bridge to rocker gap, and finally re-tighten the adjuster above the valve so that it's just touching. That way you should have the same lift on both valves.
YessWhen adjusting the bridge to rocker gap am I tightening/locking that before tightening/locking the adjuster above the valve? Thanks