Been busy taking awful pictures again today. Can't find my camera
.
You can throw these drawers in, in an hour, but I really don't want to ever take them out again, so I have been putting all the bits and pieces in for good today. There is quite a lot of cabling. There is room under the drawers but on reflection tonight I am going to run these around the units later in the week. I don't want the drawers to rub on the cables and eventually go through the insulation. It's all going to be well held down with clips etc.
[attachment=5:1c36u9nr]photo 1-2.JPG[/attachment:1c36u9nr]
The inverter just fits. Phew. I used a block of Delrin to mount the fuse holder. I don't want anything jiggling around. 'Solid' was today's watchword.
[attachment=4:1c36u9nr]photo 2-1.JPG[/attachment:1c36u9nr]
[attachment=3:1c36u9nr]photo 2-2.JPG[/attachment:1c36u9nr]
Compressors got bolted in on AV mounts. I may need to tip the seat on a long run as they do get quite hot. But if they only run for a minute or two they will be fine. I could duct a fan into there but that's a bit excessive.
[attachment=2:1c36u9nr]photo 3-1.JPG[/attachment:1c36u9nr]
I installed a voltmeter for the leisure battery with a push switch so that it's not on all the time.
[attachment=1:1c36u9nr]photo 1-1.JPG[/attachment:1c36u9nr]
And by supper time, the drawers were going back together.
[attachment=0:1c36u9nr]photo 4-1.JPG[/attachment:1c36u9nr]
Chris