Alu Hawse

[warrenpfo]

Having gone synthetic line on the winch the ARB bumper is too recessed where the hawse goes and so restricts the angle you can winch at as you will get rub if you go too acute. The only way around this is too space out the hawse you have with yet another hawse.

Looking for a cheap option as it wont be on show so does not need to be in good condition so long as it does not have any rough edges etc. Will have to check if it needs to be offset or not as I cant remember.

 

[Julian]

Warren, had you thought about using your roller fairlead with the metal rollers replaced by these
http://www.winchline.com/fairleads.html
down the page under replacement rollers
Rollers would have much less friction and should fi the bumper

 

[warrenpfo]

Yes I had and even asked Chris if he would be able to turn some for me if I provided the material BUT at the end of the day it woks out more expensive.

Link to the initial discussion

http://www.landcruiserclub.net/forums/showthread.php/44651-Lathe-job-request?highlight=hawse

 

[sae70]

This was the one that I bought for Fiery's winch install £29.99 http://www.ebay.co.uk/itm/HAWSE-FAI...arParts_SM&hash=item3cc1c1d58a#ht_2711wt_1186 in fact it came with the synthetic rope and hook from the same supplier all for £145.99 http://www.ebay.co.uk/itm/100ft-10m..._Equipment&hash=item4165fb7c8b#ht_4219wt_1139 and these remotes I only paid £18.99 for but it would seem that there must have been a typo as they're now £32.95!!! http://www.ebay.co.uk/itm/TWIN-HAND...9875?pt=UK_Recovery_Tools&hash=item41620be0e3