- Joined
- Dec 25, 2012
- Messages
- 203
Mine is in,will add some pics later. I used the bracket without the extensions fixed into where the factory cup holder thing used to be so it picks up on the steel bracket inside the centre console,then used pop rivets and very big repair washers for the front end. I was concerned about any weight on it breaking the bracket so was looking for something to brace both sides together and came up with one of those tool tray things that hang off of a wall? fixed this inside the bracket and then the original cup holder thingy on the back of that so I now have a very sturdy armrest,a rear seat cup holder(for the dog?) and a very handy,somewhat 'secret'cubby hole underneath the armrest.
Only thing in not keen on is that I used the the original screw hole for the bottom of the cup holder as a starting point,which has set the whole thing forward about an inch too far,ok if you drive with the seat wound forward a bit but I'm 6'4" and have the seat right back,right down and reclined a fair amount. Will wip it all off again later and just move it back that little bit. Overall pleased with the outcome though!
Only thing in not keen on is that I used the the original screw hole for the bottom of the cup holder as a starting point,which has set the whole thing forward about an inch too far,ok if you drive with the seat wound forward a bit but I'm 6'4" and have the seat right back,right down and reclined a fair amount. Will wip it all off again later and just move it back that little bit. Overall pleased with the outcome though!