hopeless wanderer
Well-Known Member
- Joined
- Aug 21, 2014
- Messages
- 863
- Country Flag
Before garaging the car to head off to work, I took all the measurements I needed to design a rear drawer system.
I planned the build and came up with a cutting list for the aluminium extrusion place to provide me all the bits cut and machined so i could come back and assemble it like meccano. leaving me with just the actual drawers to make from ply.
Now I've changed the design and I'm not sure if I'm going to close the upper tailgate and end up smashing the rear screen. The $64000 question is :
Will a box that's 75cm tall and 93cm deep fit in the boot and allow the tailgate to come down without the sound of breaking glass, This is with standard rear seats in the normal position.
thanks in advance to the legend who has a tape measure and an 80 that doesn't have a boot full of stuff.
I planned the build and came up with a cutting list for the aluminium extrusion place to provide me all the bits cut and machined so i could come back and assemble it like meccano. leaving me with just the actual drawers to make from ply.
Now I've changed the design and I'm not sure if I'm going to close the upper tailgate and end up smashing the rear screen. The $64000 question is :
Will a box that's 75cm tall and 93cm deep fit in the boot and allow the tailgate to come down without the sound of breaking glass, This is with standard rear seats in the normal position.
thanks in advance to the legend who has a tape measure and an 80 that doesn't have a boot full of stuff.