Always wanted one of these and now that I need to replace my wheel bearings, now's a good excuse to buy some tools...
Whats the thoughts on capacity, yes I know bigger is better , but they do start to get a bit expensive. I think for diy 10T or 15T is probably going to be plenty...
Looking at the Machine Mart site:
10T Floor standing is £260:
http://www.machinemart.co.uk/shop/produ ... loor-press
15T Floor Standing £420:
http://www.machinemart.co.uk/shop/produ ... -15t-press
I could stretch to the 15T one, but is this over board?
Then there is the 50T one for a mear £1800... but lets not go there http://www.machinemart.co.uk/shop/produ ... loor-press
Whats the thoughts on capacity, yes I know bigger is better , but they do start to get a bit expensive. I think for diy 10T or 15T is probably going to be plenty...
Looking at the Machine Mart site:
10T Floor standing is £260:
http://www.machinemart.co.uk/shop/produ ... loor-press
15T Floor Standing £420:
http://www.machinemart.co.uk/shop/produ ... -15t-press
I could stretch to the 15T one, but is this over board?
Then there is the 50T one for a mear £1800... but lets not go there http://www.machinemart.co.uk/shop/produ ... loor-press