G
Guest
Guest
Hi Guys
Cruiser went for its NCT test today and failed because of the drivers window
which the tester could not get up after opening it.
I want to work on it today and need a few pointers.
I have taken the trim of the door and pulled apart the contacts between the
switch and the door wiring loom.
Do I need to clean these little nipples on both ends and if so how and with
what.
To clean the rubber I need to use a tooth brush and fairy washing up and
then spray with silicone is that all I need to do.
I'm not into taking any motors apart because knowing me I will end up with
extra bits left over.
Would a new rubber seal fix the issue it cleaning does not.
cheers
john92HDJ 80 1HDT
--
European Land Cruiser Owners Mailing List
Further Info: http://www.landcruisers.info/
Cruiser went for its NCT test today and failed because of the drivers window
which the tester could not get up after opening it.
I want to work on it today and need a few pointers.
I have taken the trim of the door and pulled apart the contacts between the
switch and the door wiring loom.
Do I need to clean these little nipples on both ends and if so how and with
what.
To clean the rubber I need to use a tooth brush and fairy washing up and
then spray with silicone is that all I need to do.
I'm not into taking any motors apart because knowing me I will end up with
extra bits left over.
Would a new rubber seal fix the issue it cleaning does not.
cheers
john92HDJ 80 1HDT
--
European Land Cruiser Owners Mailing List
Further Info: http://www.landcruisers.info/