This is me upsetting the Mrs again
View attachment 113462
The hoops are sleeved with steel which needs to be removed to make the new bush fit . I found it very easy to crease the sleeve by tapping an narrow wood chisel in then remove the blade from a hacksaw loop it through fix it back to the handle and cut the crease .
Two bushes had been changed before and i can only guess a lamedrover mechanic did it using i know not what method leaving bits of the old sleeve to rust in solid
I left these to soak in a solution i have that is very similar to acid brick cleaner .
Prop the axle either side and where it meets the prop shaft and other than that you need a 17mm and 19mm socket and spanner . The socket won't fit on the lowest bolt behind the shock so you will need a bit of scaffold tube or something to give you enough leverage on the spanner .