Raptor Bumpers

[Neil Smith]

Fellas, a few before and after images attached of time spent re-working my bumpers with Raptor whilst time and weather permitted.

 

[Mick W]

Nice look, does it still flex with the bumper?

 

[Chris]

Sprayed my Hilux load bed with Raptor last week. Fantastic stuff.

 

[Shayne]

Looks good but just for those who don't have the equipment to spray i think i probably got a smother finish than that using these No Nonsense 4 - [Leaving Land Cruiser Club] , they ruin very quickly as soon as the raptor starts to dry but i would have been happy with the finish on my roof tent had Helen not picked up the raptor roller saying why don't you use this as she ran a stripe right across the tent so i had to do it all again to make it match

 

[Chris]

You get a gun with the kit. All you need is around 50psi of air.

 

[Neil Smith]

Just to be clear I did use a roller not a spray. The one thing I learnt from the job however is that it’s best to do all areas from the same mix of Raptor and hardener to get the same finish throughout.
I did the front and rear bumpers one day and the side door trims the day after. To be picky I can see a slightly heavier texture on the trim due to this mix being slightly thinner. This lifted the texture higher from the roller.