well, fitted mine at the weekend....
Couple of gotchas.....
For the winch mount....
The ends of the 90 chassis at the front are held on with a bolt, Found this after grinding the buggars off

Also needed to grind the flanges off the inside and bottom of the chassis ends.
The factory bash plate needs bending in either edge just a smidgen to make mounting easier.
Wire it up and load the steel / rope back on, or at the very least, put the end of the wire in and secure it before putting the bumper back on.
Use a dremel a lot.... lots of minor adjustments made a pretty tidy fit... also took the sharp edges off to get my hand in and put the wander lead on and to get to the freewheel lever without scraping my hand.
To re-fit the number plate, you can dremel out the lip above the standard mounting and drill two more holes in the plate about 2" lower (so it sits about 2" higher), but remember that the headlamp washer pipe is behind there so pop that away first.
Apart from that, get a good strong mate to help lift it with the winch and fairlead in place.... that's one heavy lump at the front with it all on! I did lift it on my own while my son fumbled the bolts several times (think I tought him some new words!) but I wouldn't advise that route!
And the sliders...
There are 2 longer bolts.... there is a reason for this.... and it's at the passenger side front you need them. Fitting the drivers side first, and not noticing 2 bolts were longer meant removal and re-mounting the drivers side

(yes, sods law said that both the long bolts were on the top of the drivers side.... )
Gotta say a huge thanks to J66P for the work he and K4 put into these. Would recommend them.
Only changes I made were.....
I had to open out the recovery point holes to fit my 4.75t shackles a tiny bit and I had to re-drill the fairlead holes out for the EP9i fairlead bolts that came with the winch (though if I had spare grade 8 bolts of the smaller size I would have used these).
Pics can be seen here:
http://www.flickr.com/photos/58477572@N ... 916346138/