G
Guest
Guest
Hi All,
Prefacing this post is my usual sob story about how my engine manual and
most of my tools are in a land far far away.... consider it sobbed.
Anyway, I desperately need to do the valve clearances on my '97 GX 80 series
and realise that I've completely forgotten how to find TDC! In know you
need a 32mm socket to turn the crank (check) and I seem to recall taking the
t-belt cover off before - but after that, I'm blank.
Please someone refresh my somewhat amnesiac memory as there is a bit of a
top end rattle when the engine is warm.
Cheers - Andy
----- Original Message -----
From: "Julian Voelcker" <[Email address removed]>
To: <[Email address removed]>
Sent: Friday, August 19, 2005 9:34 AM
Subject: Re: [ELCO] my records
Prefacing this post is my usual sob story about how my engine manual and
most of my tools are in a land far far away.... consider it sobbed.
Anyway, I desperately need to do the valve clearances on my '97 GX 80 series
and realise that I've completely forgotten how to find TDC! In know you
need a 32mm socket to turn the crank (check) and I seem to recall taking the
t-belt cover off before - but after that, I'm blank.
Please someone refresh my somewhat amnesiac memory as there is a bit of a
top end rattle when the engine is warm.
Cheers - Andy
----- Original Message -----
From: "Julian Voelcker" <[Email address removed]>
To: <[Email address removed]>
Sent: Friday, August 19, 2005 9:34 AM
Subject: Re: [ELCO] my records