Yota spares quality !!

[joinerman]

Three years ago i needed to replace the front section of exhaust on my 80,the bit with the flexi section in, i thought do i go to milners or use genuine yota, chose the latter, six months ago there was a hole just below the flexi which i repaired with a bandage from halfrauds & then wrapped some thin tin round and all held on with two jubilee clips, still holding good today BUT iv'e now got a whole just above the flexi, 20k since fitting, as i went down the genuine yota route i'm dissapointed that this has failed so soon.

I do have a backup section luckily purchased from Rob

 

[Bas]

Hi joinerman,fitted a stainless steel exaust to my 80 16 years ago and havent touched it since,if i recall rightly it cost about £350,been well worth the money and the polished tailpipe looks great.

 

[joinerman]

Just an update to say my repair is still holding up.


Probably the kiss of death saying this, lol

 

[Ben]

How much did you pay for the genuine exhaust compared to milners?

 

[Cptsideways]

My Milners one is still like new after 3 years

 

[joinerman]

Ben, if i remember correctly it was about £165. only talking about the front section though.